控制中心空调解决方案

 恒温恒湿空调    |      2016-04-06
针对控制中心的空调解决方案,控制中心的特点为监控设备的即时动态,设备放置室有大量发热设备,控制中心内人员不会太多。根据控制中心的特点,空调选型推荐如下:HIMOD S13机型。
This is a solution of A/C for a control room. The characteristic of the control room is the workplace for real-time monitoring, and there is a large amount of equipment in an equipment room. Production personnel are not too much. According to the characteristics for the control room, the selection of model is recommended as HIMOD S13.
经济效益评估:(Economic Evaluation)
  • 该控制中心需安装空调面积总计100平方米左右,有大量发热设备,对温湿控制及节能有要求,依据实际情况每平米所需制冷量平均按350W计算,总需求的35KW制冷量。
The total area is of about 100 square meters for the control room, and there is a large amount of heat source, and it requires the temperature and humidity control and energy saving features. Required cooling capacity per square meter on average calculated based on the actual situation according to 350W, the total demand for cooling capacity is of 35KW.
  • 要满足该项目35KW的制冷量,需使用HIMOD S13机组3套装机。
To meet the cooling capacity of 35KW, this project is needed to use three sets of units (HIMOD S013 x 3).
  • 经济效益对比估算:传统空调满足35KW制冷量的输入功率至少为12KW左右,而HIMOD S13机组3套主机的输入功率合计为7.6KW,主机部分省电36.6%,全年共计节省电费0.84万元以上。(按1年运行8个月,1月运行30天,1天运行8小时,用电按1元1度计算)
Comparison of economic benefit estimation: the traditional air-conditioning input power (35KW cooling capacity) is at least about 12KW and the input power for HIMOD S13 (x3) is of 7.6KW. The energy saving is up to 38.6%. The annual saving is more than 8400 CNY. (According to 8 months per year, 30 days per month, 8 hours per day of operation, electricity by 1 CNY/1 degree calculation)